Brand new ergometer which simulates the motion of stereotype cross country sport for test and training.
The CROSS COUNTRY ERGOMETER is a brand new product which gives recreational and top-athletes the best opportunity to simulate the motion stereotype of cross country sport for test and training. The complexity of the smooth and gentle motions increases the muscles strength and flexibility of the upper body.
Display Device
Display Device Main Characteristics
- Backlight
- Rechargeable battery with about 15 hours of authonomy
- After switching ON, the last screen settings appear
- Graphic display
- Display options including graphical or numerical data
- Time, Stroke rate, Power, Work, Force, Heart rate
- Choose from a variety of units - Power (W) or Force (N) - to be displayed with bigger fonts in the middle of the display. Switch between the units during a workout using UP/DOWN buttons
- Pre-programming the workouts with time, rest time and numbers of intervals
- Store workout data on the board memory or just work without recording
- Recall function
- Memory status
- Battery status
- PC COM interface (USB)
- Real-time monitoring on the performance monitor or PC
- The accuracy control or calibration is possible at any time with PC
Display Device Modes
Two modes for presentation of the measured and calculated parameters are available:
- Text mode
- graphic mode
Text mode
In text mode, it is possible to monitor five parameters at the same time.
Time, Cadence and Heart Rate are standard fields that are presented in all text modes. Main and Average field could be switched to different views pressing UP and DOWN buttons.
The following views are avaliable: Power [W], Force [N],Length [cm], Energy [J], Graph mode.
Graphic mode
In graph mode, two parameters can be followed at once.
In the upper part of the display (Left & Right Average Value) are numerical values of the measured parameters (POWER, FORCE
) and this values are refreshed after each stroke. Left & Right Graph represents graphical interpretation of the measured parametar. Two bars at the middle of the display are presentation of the last stroke, shown separatlyto allow easy comparation of two sides (left & right force, left & right power etc.).
In graph mode, four different views are avaliable. Three of them are predefined (Forces, Lengths, Power & HR). The last one is Custom mode. Switching through views can be done by pressing ENTER button.
Memory capacity
Data recorded during a session is put in the memory. Its capacity depends on the sampling rate (table below). The Memory indicator in the Status bar shows the fullness of this memory.